2 Button Remote Flip Key Blank Shell Case For Holden Barina/Cruze/Trax

Specifications

Manufacturer: Auto Openers
Made To Replace: For Holden
Keyblade Model: HU100
Case Dimensions: 6.6 x 3.6 x 1.8 (cm)

Car Key Blade Case Replacement For Holden Compatibility

This Auto Openers will replace your old and worn out For Holden or Chevrolet car key case and shell. Below are some For the Holden car models that use this car remote. However, please ensure that your car remote and buttons look the same as pictured.

For Holden Car Key Models

Barina (TM) 2011 – 2014Cruze (JG) 2009 – 2010Cruze (JH) 2010 – 2014Trax 2013 – 2014Holden VF Commodore

For Chevrolet Car Key Models

Camaro 2010 – 2013Cruze 2011 – 2013Equinox 2010 – 2013Malibu 2013Spark 2013Sonic 2011-2012Volt 2011-2013

How Do I Replace My Holden Key Buttons

Replacing the case on your Holden car remote is very simple and can be done by anyone. You only need a small, flathead screwdriver (or similar tool) and 1 minute.

1. Press the button to open the key blade on your old car key, which will reveal a small hole in the side of the car key case.’
2. Insert a screwdriver into that hole and pry open the case, but be careful! There will be a spring that is under some tension and can fall out.
3. Remove the internal circuit board and key blade. Please check your circuit board to ensure that the transponder is present on the circuit board. This is a small, rectangual chip present on the pointed part of the circuit board. If it is not present, check the top right portion of the keycase. It will need to be moved over.
4. Insert the circuit board, transponder and transponder cover into the new car key case.
5. Click and screw together the new case, then test to ensure that everything is working fine.

Please note, sometimes the original key blade does not suit our replacement case. If this occurs, you will need to have the key cut by an automotive technician or locksmith. If you are reasonably handy, we do have some steps below submitted by a client on how to adjust your new repalcement car key case.

1. Take a 0.8 mm pin punch and use it to remove the pin from both the new and old car key blades. Keep the pins.
2. Note that the pin is inserted into a slot in the blade, which is slightly misaligned in the old blade compared to where it should be in the new one.
3. Use a needle file to carefully elongate the slot in the correct direction, checking the alignment with the old blade in the new swivel fixture until you can see through the pin hole.
4. Once the slot is elongated correctly, use the original blade in the new swivel assembly to drive the pin back in, and then reassemble the key.

Package Incl.:
1pcx Replacement Case For Holden Car Key

Please note:
This product is a blank blade and empty case replacement. This is not a functioning remote. You will need to have the key cut by your local locksmith or similar outlet.

—————————————————————